Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 159 Operands: S 1 : Numbers of pulses (Absolute positioning) S 2 : Pulse output frequency D 1 : Pulse output device D 2 : Direction signal output Explanations: 2. S 1 is the number of pulses (Absolute positioning). Available range: -2,147,483,648 ~ 1. The instruction only supports the pulse output type: Pulse + Direction. +2,147,483,647. “+/-” signs indicate forward and reverse direction. 3. S 2 is the pulse output frequency. Available range: 6 ~ 100,000Hz. 4. D 1 is the pulse output device. It can designate CH0 (Y0) and CH1 (Y2). 5. D 2 is the direction signal output device.

If Y output is designated, only CH0 (Y1) and CH1 (Y3) are available. 6. ES2/EX2 V3.46; ES2-C V3.48; ES2-E: V1.00 and later versions support the settings in D 1 and D 2 as shown below. 7. S 1 is the target position for absolute positioning. The actual number of output pulses ( S 1 – current position) will be calculated by PLC. When the result is positive, pulse output executes forward operation, i.e. D 2 = OFF; when the results is negative, pulse output executes reverse operation, i.e. D 2 = ON. 8. The set value in S 1 is the absolute position from zero point.

The calculated actual number of output pulses will be the relative position of - current position (32-bit data) of CH0 (Y0, Y1) which is stored in D1031(high), D1030 (low) - current position (32-bit data) of CH1 (Y2, Y3) which is stored in D1337(high), D1336 (low). In reverse direction pulse output, value in (D1031, D1330) and (D1336, D1337) decreases. 3-410 Mnemonic Operands Function Controllers D DRVA Absolute Position Control ES2/EX2 SS2 SA2 SX2 SE Typ e OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F DRVA: 9 steps DDRVA:

17 steps S 1 * * * * * * * * * * * S 2 * * * * * * * * * * * D 1 * D 2 * * * PULSE 16-bit 32-bit SA2 SA2 SA2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE Pulse output device (D 1) Y0 Y2 Corresponding direction signal output device (D 2) Y1 Y3 Pulse output device (D 1) Y0 Y1 Y2 Y3 Corresponding direction signal output device (D 2) Y4 Y5 Y6 Y7