Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set 9. D1343 (D1353) is the ramp up/down time (between start frequency and pulse output frequency) setting of CH0 (CH1). Available range: 20 ~ 32,767ms. Default: 100ms. PLC will take 20ms as the set value when specified value is below 20ms or above 32,767ms. 10. D1340 (D1352) is start/end frequency setting of CH0 (CH1). Available range: 6 ~ 32,767Hz. PLC will take the start/end frequency as the pulse output frequency when pulse output frequency S 2 is smaller or equals the start/end frequency. 11. M1305 and M1306 can change the output direction of CH0/CH1 set in D 2 .

When S is “-“, D 2 will be ON, however, if M1305/M1306 is set ON before instruction executes, D 2 will be OFF during execution of instruction.. 12. Ramp-down time of CH0 and CH1 can be particularly modified by using (M1534, D1348) and (M1535, D1349). When M1534 / M1535 = ON, CH0 / CH1 ramp-down time is specified by D1348 / D1349. 13. If M1078 / M1104 = ON during instruction execution, Y0 / Y2 will pause immediately and M1538 / M1540 = ON indicates the pause status. When M1078 / M1104 = OFF, M1538 / M1540 = OFF, Y0 / Y2 will proceed to finish the remaining pulses. 14. DRVA/DDRVA instructions do NOT support Alignment Mark and Mask function. 15.

When M1334 or M1335 is enabled, execute API158 DDRVI instruction on CH0 (CH1) to ramp-down when the conditional contacts are closed. This function is available for the followings: Program Example: target frequency 2kHz. Y1 = OFF indicates positive direction. When M10 = ON, DRVA instruction executes absolute positioning on Y0 at target position 20000, M10 Points to note: 1. Operation of absolute positioning: Pulse output executes according to the specified absolute position from zero point +3,000 Ramp up time Ramp down time 0 Start / End freq. Min:

6Hz Target position Zero point 0 3-411 12SA2/ Series ES2/EX2 ES2-C ES2-E SS2 12SE 26SE 28SA2 SX2 Firmware V3.42 V3.48 V1.00 V2.86 V3.28 -- V2.0 V3.0 version DRVA K20000 K2000 Y0 Y1