DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming (D212, D214). b) Select “draw clockwise arc” and default “motion time” ( S = D100 = K0) c) RUN the PLC. Set ON M0 to start the drawing of the ellipse. 3. Operation: When PLC runs and M0 = ON, PLC will start the drawing of the first segment of the arc. D0 will plus 1 whenever a segment of arc is completed and the second segment of the arc will start to execute automatically. The operation pattern repeats until the fourth segment of arc is completed. Program Example 2: 1. Draw a tilted ellipse as the figure below.
Y (34000,18000) X (0,0) 3-468 = D0 K1 DCIMA D200 D202 D100 Y0 = D0 K2 DCIMA D204 D206 D100 Y0 = D0 K3 DCIMA D208 D210 D100 Y0 = D0 K4 DCIMA D212 D214 D100 Y0 M0 RST M1029 DMOV K0 D1030 DMOV K0 D1336 MOV K0 D100 MOV K1 D0 M0 M1029 INCP D0 END END DCIMA D200 D202 D100 Y0 DCIMA D204 D206 D100 Y0 DCIMA D208 D210 D100 Y0 DCIMA D212 D214 D100 Y0 RST M1029 DMOV K0 D1030 DMOV K0 D1336 MOV K0 D100 MOV K1 D0 INCP D0 (26000,260 (8000,-8000)