3. Instruction Set Program Example 1: 1. Assume S 1 = 500, S 2 = 168 and S 3 = -4. When X0 = ON, SCAL instruction executes and the result of proportional calculation will be stored in D0. 2. Equation: D0 = (500 Ч 168 ) ч 1000 + (-4) = 80 X0 Destination value Slope=168 Offset=-4 D Source value 1 0 = 500 Program Example 2: 1. Assume S 1 = 500, S 2 = -168 and S 3 = 534. When X0 = ON, SCAL instruction executes and the result of proportional calculation will be stored in D10.. 2. Equation: D10 = (500 Ч -168 ) ч 1000+ 534 = 450 X10 Destination value D Offset = 534 Source value Points to note: 0 1. This instruction is applicable for known slope and offset.
If slope and offset are unknown, please use SCLP instruction for the calculation. 2. S 2 has to be within the range -32,768 ~ 32,767. If S 2 exceeds the applicable range, use SCLP instruction instead. 3. When adopting the slope equation, the max source value must be larger than min source value, 4. If D > 32,767, D will be set as 32,767. If D D will be set as -32,768. but the max destination value does not need to be larger than min destination value. 3-487 0 SCAL K500 K168 K-4 D0 SCAL K500 K-168 K534 D10 Slope = -168 S 1 = 500