Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set OFF), the initialization complete flag (M1615) will be cleared to OFF and related actions on other slaves will also be paused. After all the troubles are cleared, you need to initialize every slave to restart the operation. If the axes are working independently and the communication is working properly, you can set the M1617 to ON (indicating when one goes down, only the defective driver is OFF) to notify PLC to record the specific error on the error log and other slaves can keep working. Initialization and operation process chart (Firmware V3.60 or later) PLCRun P LC sending initialization No Initialization complete Set up error record ex:

Serv o, VF D disconnected Set up initialization complete flags M1615 PLCRun Clear initialization complete flags M1615 Wait for the PLC to run Determine if the heartbeat works normally Abnormal PLCStop Normal Stop heartbeat function and stop servo & VFD Example of Communication with Delta servo ASDA 1. Connect the ES2-C Series PLC to TAP-CN03 and an ASDA series with a CANopen communication cable as shown in the figure below. 2. Follow the steps below for the basic settings on the panel of the ASDA. a. Set the servo parameter P2-08 to 10 to restore the factory settings. b. Power the servo off and back on again.

3-541 Execute the communication instructions for positioning Clear initialization complete flags M1615