3. Instruction Set For firmware V3.48 or eariler versions: after finding the origin (Sensor or Z), the motor has to decelerate to stop. The stop position will slightly exceed the origin.
M1 = Off→On, starts homing and moves towards the reverse direction Reaching the first high speed Finding the origin (Sensor or Z) After decelerating to stop, it moves towards the forward direction Reaching the second low speed After leaving origin and then meeting the first Z phase, it starts to decelerate After decelerating, it stops For firmware V3.60 or later, you can use ZRNM instruction to set whether executing homing to the exact origin point or not (default is not coming back to the exact origin point). 3-559