Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set 16. The instruction supports the following series and firmware versions 17. Here is the CAN BUS format and every bit of content for Msg. ID is explained as below. As 2.0A protocol is selected and the value of S 2 is H0123, the Msg. ID content is shown in the following table. As 2.0B protocol is selected, the value of S 2 is set to H1234 (Lo-word) and S 2 +1 is H0567 (Hi-word), the Msg. ID content is shown in the following table. Example 1 System set: DVP12SA211T + DVPCOPM-SL Mode: Master mode (receiving after sending) MBB device Diagnostic description as below PLC program design:

Step 1) SET M1620  2.0A protocol Step 2) RST M1621 & M1622  Master mode; receiving after sending; set timeout to 200 ms 3-585 12SA2/ 12SE 32ES2-C SV2/ COPM-SL 12SA2/ Series 20SX2 EH3-L 20SX2 FW V3.0 V1.88 V3.60 V2.2 V1.36 V3.0 Version Bit No. 15 ~ 11 10 ~ 8 7 ~ 4 3 ~ 0 S 2 value (16bits) - 1 2 3 Bit No. 31 ~ 29 28 27 ~ 24 23 ~ 20 19 ~ 16 15 ~ 0 S 2 value (32bits) - 0 5 6 7 1234