DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 1. The instruction used for transferring the step (SET S □ or OUT S □ ) are suggested to be Other Points to Note: executed after all the relevant outputs and actions in the current step are completed. The execution results by the PLC are the same. However, if there are many conditions or actions in S10, it is recommended to modify the diagram in the left into the diagram in the right, which executes SET S20 after all actions are completed. The sequence will be more understandable and clear with this modification. S10 S10 S S S20 S Y2 S20 S Y2 2.
As indicated in the below diagram, make sure to connect RET instruction directly after the step point rather than the NO or NC contact. S0 S20 X1 S RET S0 S20 X1 S RET 5.4 Points to Note for Designing a Step Ladder Program 1. The first step in the SFC is called the “initial step", S0 ~ S9. Use the initial step as the start of a 2. If no STL instruction is in use, step point S can be used as a general-purpose auxiliary relay.. sequence and ends with RET instruction. 3. When STL instruction is in use, the No. of step S cannot be repeated. 4. Types of sequences: Single sequence:
Only one simple sequence without alternative divergence, alternative convergence, simultaneous divergence or simultaneous convergence in the program. Complicated single sequence: Only one sequence with alternative divergence, alternative convergence, simultaneous divergence and simultaneous convergence in the program. Multiple sequences: More than one sequence in a program, maximum 10 sequences, S0 ~ S9. 5-10 0 Y0 SET S20 Y1 0 Y0 Y1 SET S20 SET S20 SET S20