Delta DVP-ES2 — 6.2 Error code Table (Hex)

6.

Troubleshooting 6-5 Error code Description Action 0E18 BCD conversion error Check the D1137 (Error step number) Re-enter the instruction correctly 0E19 Division error (divisor=0) 0E1A Device use is out of range (including index registers E, F) 0E1B Negative number after radical expression 0E1C FROM/TO communication error 0F04 Operand word device D register exceeds limit 0F05 DCNT operand DXXX misuse 0F06 SFTR operand misuse 0F07 SFTL operand misuse 0F08 REF operand misuse 0F09 Improper use of operands of WSFR, WSFL instructions 0F0A Times of using TTMR, STMR instruction exceed the range 0F0B Times of using SORT instruction exceed the range 0F0C Times of using TKY instruction exceed the range 0F0D Times of using HKY instruction exceed the range 1000 ZRST operand misuse 10EF E and F misuse operand or exceed the usage range 2000 Usage exceed limit (MTR, ARWS, TTMR, PR, HOUR) Error code Description Action C400 An unrecognized instruction code is being used A circuit error occurs if a combination of instructions is incorrectly specified.

Select programming mode and correct the identified error A circuit error occurs if a combination of C401 Loop Error C402 LD / LDI continuously use more than 9 times C403 MPS continuously use more than 9 times C404 FOR-NEXT exceed 6 levels C405 STL / RET used between FOR and NEXT SRET / IRET used between FOR and NEXT MC / MCR used between FOR and NEXT END / FEND used between FOR and NEXT C407 STL continuously use more than 9 times C408 Use MC / MCR in STL, Use I / P in STL C409 Use STL/RET in subroutine or interrupt program C40A Use MC/MCR in subroutine Use MC/MCR in interrupt program C40B MC / MCR does not begin from N0 or discontinuously C40C MC / MCR corresponding value N is different