Delta DVP-ES2 — 7.2.1 The Dimensions

7 CANopen Function and Operation  If the CAN port functions as a slave, it has the following functions.  It supports the standard CANopen protocol DS301 V4.02.  It supports the NMT (network management object) service.  It supports the NMT state control. The state of DVP-ES2-C in the CANopen network is controlled by a master.  It supports the NMT error control. Heartbeat is supported, but Node Guarding is not supported.  It supports the PDO (process data object) service.  The PDO message is used to transmit the immediate input data and output data.  It supports 8 TxPDO at most, and 8 RxPDO at most.  The PDO transmission type:

The synchronous mode, and the asynchronous mode  It supports the emergency service. If an error or an alarm occurs in DVP-ES2-C, the master is notified through the emergency. 7.1.2 The Input/Output Mapping Areas DVP-ES2-C as a master supports 16 slaves at most, and the slave node ID range from 1 to 16. The output mapping areas are D6250-D6476, and the input mapping areas are D6000-D6226. If DVP-ES2-C functions as a slave station, the output mapping areas are D6282-D6313, and the input mapping areas are D6032-D6063.

7.2 The Installation and the Network Topology This section introduces the dimensions of DVP-ES2-C, the CAN interface, the CANopen network framework, and the communication distance. 7.2.1 The Dimensions 106 110 L1 61.5 L 78 Unit: millimeter 7-3 Mapping Device in the PLC Mapping area length SDO reque D6250~D6281 Emergency st information, NMT service information, and request information 64 bytes SDO reply i D6000~D6031 information nformation, and Emergency reply 64 bytes D6282~D6476 RxPDO ma pping area 390 bytes D6032~D6226 TxPDO ma pping area 390 bytes Mapping Device in the PLC Mapping area length D6032~D6063 RxPDO ma pping area 64 bytes D6282~D6313 TxPDO ma pping area 64 bytes 90 98