Delta DVP-ES2 — 7.2.3 The CAN Interface and the Network Topology

7 CANopen Function and Operation 7-7 Product Model Function DVPCOPM-SL DVPCOPM-SL is a module connected to the left side of an S series PLC. It can function as the CANopen master or slave. The PLCs which can be connected to DVPCOPM-SL are DVP-28SV, DVP-28SV2, DVP-SX2, DVP-SA2, and DVP-EH2-L. IFD9503 It converts CANopen to the Modbus gateway, and connects the device (with the RS-232 or RS-485 interface) which conforms to the standard Modbus protocol to the CANopen network. 15 devices at most can be connected. DVPCP02-H2 It is the CANopen slave module, and is connected to the right side of an EH2 series PLC. It can connect the EH2 series PLC to the CANopen network.

IFD6503 It is a tool used to analyze the CANopen network data. The interfaces at both ends are the CAN interface and the USB interface. It can be used to catch the CAN network data, or allow the CAN nodes to transmit the data. The product is used with the software Netview Builder. ASD-A2-xxxx-M servo driver It is a servo driver with the built-in CANopen interface. It controls the positioning, speed, and torque. C2000/CP2000/C200 series AC motor drives It is an AC motor drive with the built-in CANopen function, and controls the positioning, speed, and torque. Before using the CANopne function of the C2000/CP2000 series AC motor drives, users need to purchase CMC-COP01.

This card only provides the CAN interface. The C200 series AC motor drive has the built-in CANopen interface.