DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Response data: NMT service can be used managing the CANopen network such as start, operation, reset of nodes and etc. The data format of the NMT request message: 7.4.2 Data Structure of NMT Message Command: Fixed to 01. ReqID: The request ID. Whenever an NMT request message is sent out, the message will be given a ReqID for the CANopen master to identify. Before another NMT request message is sent out, the original ID number must be changed. In other words, to send out the NMT request message is triggered by changing of the value of “ReqID”. ReqID range: 00 (Hex) ~ FF (Hex). Node ID:
The node address of the target equipment on CANopen network. (0: Broadcast) NMT service code: The data format of the NMT Response message: When status code is 1, it indicates that NMT operation succeeds. When status code is not equal to1, it indicates that NMT operation fails and in the meantime, you should check if the data in NMT request message are correct. Node ID: The node address of the target equipment on CANopen network.
7-18 Response message PLC device High byte(Hex) Low byte(Hex) D6000 Message Header ResID =01 Command =01 D6001 Reserved =0 Size =8 D6002 Type =43 Node ID =03 D6003 Message data Main index high byte =21 Main index low byte =09 D6004 Reserved =0 Subindex =0 D6005 Datum 1=03 Datum 0=E8 D6006 Datum 3=01 Datum 2=02 Request message PLC device High byte Low byte D6250 Message Header ReqID Command (Fixed to 01) D6251 Reserved Size (Fixed to 04) D6252 Type (Fixed to 03) Node ID D6253 Message data Reserved NMT service code D6254 Reserved Node ID NMT service code (Hex) Function 01 Start remote node 02 Stop remote node 80 Enter the pre-operational state 81 Reset application 82 Reset communication Response message PLC device High byte Low byte D6000 Message header ResID Status code D6001 Reserved Reserved D6002 Reserved Node ID