DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming The mapping relation between master and slave: Program control: D6282 is given the value K256 through WPL software. That is, the speed command is set as 256r/min. See details in the following figure. Program explanation: While DVP-ES2-C is running for the first time, set the parameter P3-06 of servo drive to F. When M0 turns from OFF to ON, write K256 to D6282 and then the value is written to P1-09 of servo parameter through RxPDO1. When M1 turns from OFF to ON, turn P2-12 on and call the speed specified by parameter P1-09 of servo for rotation.
When M1 turns from ON to OFF, the speed command becomes 0 and the motor stops running. 7-32 Data transmission on DVP-ES2-C master register A2 device CANopen bus Low word of P1-09 of D6282 servo D6283 High word of P1-09 of servo D6284 P3-06 of servo D6285 P4-07 of servo D6032 Low word of P0-09 of servo D6033 High word of P0-09 of servo