Appedndix B Setting and Using an Ethernet PLC/Module B.3 Searching for an Ethernet PLC a setup page, you have to select Ethernet in the Communication Setting window. Next, you This section introduces how to search for and set an Ethernet PLC by DCISoft. Before you start can search by a broadcast, or an IP address. An Ethernet PLC is set up by UDP port 20006; therefore, you have to be aware of the relevant settings of the firewall. B.3.1 Communication setting (1) Start DCISoft in your PC, and click Communication Setting on the Tools menu. B-7 DVP-FEN01 Ethernet communication card CR number Attribute Register name Description HW LW #94 R/W Enabling the IP address setting 0:
The setting of the IP address is not executed. 1: The setting of the IP address is executed. #95 R IP address setting status 0: The setting is unfinished. 1: The setting is being executed. 2: The setting is complete. #250~#96 - Reserved #251 R Error status bit 0: The network is unconnected. bit 3: CR#13 is set to “sending the data”, but the data exchange is not enabled. bit 8: DHCP does not acquire the correct network parameter. #255~#252 - Reserved Symbols “R” refers to “able to read data by FROM instrcution”; “W” refers to “able to write data by TO instrcution”.