DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 3. Use DCISoft for DVP-SE to set start addresses and numbers. (RX: M2000~M2009; RY: M3000~M3009; RCR (Reading): D2000~D2009; RCR (Writing): D3000~D3009) 4. Edit a ladder diagram, and download it to DVP-SE. The program edited is like the one shown below. Description: (1) Enabling mapping: CR15=1 (2) Disabling mapping: CR15=0 (3) After CR#15 is enabled, M2000~M2009 and D2000~D2009 will be used to read data, and present values will be read before M3000~M3009 and D3000~D3009 are used to write data. ※ During the execution of mapping, other devices can not be used to modify the values in mapping registers.
※ If DVPEN01-SL is used, K108 will be changed to the number assigned to DVPEN01-SL. If DVPEN01-SL is the first module connected to the left side of a PLC, K108 will be changed to K100. B-22