Delta DVP-ES2 — B.6.2 Application of the RTU Mapping

Appedndix B Setting and Using an Ethernet PLC/Module B.6.2 Application of the RTU Mapping 1. Please refer to section B.6.1 for more information about setting communication. 2. Use DCISoft for RTU-EN01 to set mapping control registers used for reading/writing. B-21 Application Using RTU mapping to read data from/write data into remote digital inputs/outputs and analog input/output registers DVP-SE/ES2-E  RTU-EN01+DVP06XA+DVP16SP Network environment (1) Use a static IP address. (2) IP address of DVP-SE: 192.168.1.90 (3) IP address of RTU-EN01: 92.168.1.91 (4) Use DCISoft for RTU-EN01, and check 10 pieces of mapping data for reading and 10 pieces of mapping data for writing.

(5) Set a start RX address, a start RY address, a start RCR (reading) address, and a start RCR (writing address) in DVP-SE, and set corresponding numbers. (6) Enable the mapping function in DVP-SE. Use M2000 and D2000 in DVP-SE to read values from RTU-EN01, and use M3000 and D3000 to write values into RTU-EN01.