Appendix C Inforamation about TP Series Text Panels C-5 OFF STOP RUN Special Content Latch Attrib. Default D -ed ON RUN STOP D1062* Average number of times an analog signal is input - - - R/W YES 2 D1067* Error code for program execution error 0 0 - R NO 0 D1068* Address of program execution error 0 - - R NO 0 D1070 ↓ D1085 Feedback data (ASCII) of Modbus communication. When PLC’s RS-485 communication instruction receives feedback signals, the data will be saved in the registers D1070~D1085. Usres can check the received data in these registers.
0 - - R NO 0 D1086 High word of the password in DVP-PCC01 (displayed in hex according to its ASCII codes) 0 - - R/W NO 0 D1087 Low word of the password in DVP-PCC01 (displayed in hex according to its ASCII codes) 0 - - R/W NO 0 D1089 ↓ D1099 Sent data of Modbus communication. When PLC’s RS-485 communication instruction sends out data, the data will be stored in D1089~D1099. Users can check the sent data in these registers. 0 - - R NO 0 D1109* COM3 (RS-485) Communication protoco H’86 - - R/W NO H’86 D1110* Average value of analog input channel 0 (AD 0) When average times in D1062 is set to 1, D1110 indicates present value.
0 - - R NO 0 D1111* Average value of analog input channel 1 (AD 1) When average times in D1062 is set to 1, D1111 indicates present value 0 - - R NO 0 D1112* Average value of analog input channel 2 (AD 2) Whenaverage times in D1062 is set to 1, D1112 indicates present value 0 - - R NO 0 D1113* Average value of analog input channel 3 (AD 3) Whenaverage times in D1062 is set to 1, D1113 indicates present value 0 - - R NO 0 D1114* Setting the mode of analog input/output (available for TP04P) Bit 11-10 9-8 7-6 5-4 3-2 1-0 Channel CH5 CH4 CH3 CH2 CH1 CH0 Setting the mode of input: 00: Voltage mode 01: Current mode (0~20mA) 11: Current mode (4~20mA) Setting the mode of output: 00: Voltage mode 01:
Current mode - - - R/W YES 0 D1115* Analog input/output mode setting (available for TP70P) - - - R/W YES 0 D1116* Output value of analog output channel 0 (DA 0) 0 0 0 R/W NO 0 D1117* Output value of analog output channel 1 (DA 1) 0 0 0 R/W NO 0 D1118* Sampling time of analog/digital converstion. Default: 2. Unit: 2 - - R/W YES 2 Bit 11-10 9-8 7-6 5-4 3-2 1-0 Channel CH5 CH4 CH3 CH2 CH1 CH0