DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming C-4 OFF STOP RUN Special Content Latch Attrib. Default D -ed ON RUN STOP D1000* Setting value of the watchdog timer (WDT) (Unit: 1ms) 200 - - R/W NO 200 D1001 Displaying the firmware version of TP (For example, the firmware version is 1.0 if the value in D1001 is HXX10.) - - - R NO # D1002* Program capacity 7920 - - R NO 7920 D1003 Sum of the PLC internal program memory - - - R YES 7920 D1004* Syntax check error code 0 0 - R NO 0 D1008* Step address when WDT is ON 0 - - R NO 0 D1009 Number of LV (Low voltage) signal occurrence - - - R YES 0 D1010* Current scan time (Unit: 0.1ms) # # # R NO 0 D1011* Minimum scan time (Unit:
0.1ms) # # # R NO 0 D1012* Maximum scan time (Unit: 0.1ms) # # # R NO 0 D1015* Value of accumulative high-speed timer (0~32,767, unit: 0.1ms) 0 - - R/W NO 0 D1018* πPI (Low word) H’0FDB H’0FDB H’0FDB R/W NO H’0FDB D1019* πPI(High word) H’4049 H’4049 H’4049 R/W NO H’4049 D1022 Counting mode selection (Double frequency/ 4 times frequency) for AB phase counter (From X0, X1 input) 4 - - R/W NO 4 D1025* Code for communication request error 0 - - R NO 0 D1028 Index register E0 0 - - R/W NO 0 D1029 Index register F0 0 - - R/W NO 0 D1036* COM1 (RS-232) communication protocol H’86 - - R/W NO H’86 D1038* 1. Delay time setting for data response when PLC is SLAVE in COM2 / COM3 RS-485 communication.
Range: 0 ~ 10,000 (unit: 0.1ms). 2. By using PLC LINK in COM2 (RS-485), D1038 can be set to send next communication data with delay. Range: 0 ~ 10,000 (Unit: one scan cycle) - - - R/W NO 0 D1039* Fixed scan time (ms) 0 - - R/W NO 0 D1040 No. of the 1st step point which is ON. 0 - - R NO 0 D1041 No. of the 2nd step point which is ON 0 - - R NO 0 D1042 No. of the 3rd step point which is ON. 0 - - R NO 0 D1043 No. of the 4th step point which is ON 0 - - R NO 0 D1044 No. of the 5th step point which is ON. 0 - - R NO 0 D1045 No. of the 6th step point which is ON 0 - - R NO 0 D1046 No. of the 7th step point which is ON. 0 - - R NO 0 D1047 No.
of the 8th step point which is ON 0 - - R NO 0 D1049 No. of alarm which is ON 0 - - R NO 0 D1050 ↓ D1055 Converted data for Modbus communication data processing. PLC automatically converts the ASCII data in D1070~D1085 into Hex data and stores the 16-bit Hex data into D1050~D1055 0 - - R NO 0