Appendix C Inforamation about TP Series Text Panels Notes: 1. Non-latched area cannot be modified. 2. Latched area cannot be modified. 3. COM2: built-in RS485 port. 4. There are 16-point models, and 32-point models. Extension modules are not supported. C.2 Special Data Register The types and functions of special registers (special D) are listed in the table below. Care should be taken that some registers of the same No. may bear different meanings in different series MPUs. refers to “read only”, “R/W” refers to “read and write”, “-“ refers to the status remains unchanged Special M and special D marked with “*” will be further illustrated in 2.13.
Columns marked with “R” and “#” refers to that system will set it up according to the status of the PLC. For detailed explanation please also refer to the table below.
C-3 Specifications T Current value T0~T255, 256 words C0~C199, 16-bit counter, 200 words C Current value C200~C254, 32-bit counter, 55 words D0~D407, 408 words, (*1) D600~D999, 400 words, (*1) D3920~D3999, 80 words, (*1) Total 5000 General Word D408~D599, 192 words, (*2) D2000~D3919, 1920 words, (*2) Register Data Latched D register D1000~D1999, 1000 words, some are latched D4000~D4999, 1000 words, (*3) Special Index E0~E7, F0~F7, 16 words, (*1) N Master control loop N0~N7, 8 points P Pointer P0~P255, 256 points I000/I001(X0), I100/I101(X1) (01: rising-edge trigger , 00:
falling-edge trigger ) External interrupt NA Pointer Timer interrupt Interrupt I Service High-speed I010,1 point counter interrupt Communication I150(COM2), 1point, (*3) interrupt K-32,768 ~ K32,767 (16-bit operation) K-2,147,483,648 ~ K2,147,483,647 (32-bit operation) K Decimal Constant H0000 ~ HFFFF (16-bit operation) H00000000 ~HFFFFFFFF (32-bit operation) H Hexadecimal COM1: built-in USB (Slave) COM2: built-in RS-485 (Master/Slave) COM3: built-in RS-485 (Master/Slave) COM1 is typically the programming port. Serial ports Real Time Clock Year, Month, Day, Week, Hours, Minutes, Seconds