Chapter 10 CANopen Function and Operation 10 10-9 Product Model Function IFD9503 The IFD9503 gateway converts CANopen to Modbus, and connects a device (with an RS-232 or RS-485 interface) that conforms to the standard Modbus protocol to a CANopen network. You can connect up to 15 devices. DVPCP02-H2 The CANopen slave module is connected to the right side of an EH2 series PLC. It can connect the EH2 series PLC to a CANopen network. IFD6503 This analyzes CANopen network data, and has ports both ends for a CAN interface and a USB interface. Use it to monitor CAN network data, or allow CAN nodes to transmit the data. The product is used with the Netview Builder software.
ASD-A2-xxxx-M servo driver This servo driver has a built-in CANopen interface. It controls positioning, speed, and torque. VFD-C2000/CP2000/C200 series AC motor drives This AC motor drive has a built-in CANopen function, and controls positioning, speed, and torque. For the C2000/CP2000 series AC motor drives, you must purchase a CMC-COP01 to provide the CAN interface. Only the C200 series AC motor drive has the built-in CANopen interface. VFD-EC series AC motor drive The EC series AC motor drive has a built-in CANopen interface. It controls speed and torque.