Delta DVP-ES3 — 4.3.2 Installation on the Set

Chapter 4 Installing Hardware 4.3.2 Installation on the Set 4_ Method 1 – Direct installation: Use M4 screws on the mounting hole to fasten the module. Method 2 – Installation with a DIN rail  Install the module on a DIN rail. 1. Link the module onto the DIN rail as the number 1 arrow indicated. 2. Push the module into the DIN rail as the number 2 arrow indicated, until you hear a click. 3. Make sure they are hooked together and the installation is done.  Remove the module from a DIN rail 1. Use a flat head screwdriver to unlink the module from the DIN rail. 2. Pull the module away from the DIN rail. 4-7 Step 4:

Push the two I/O module securing clips towards the directions as the arrows below shown to hook the modules together.