Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions Example 1. Taking (40000, 50000) as the center O and (10000, 10000) as point A, draw a circle as shown below. 3. Steps:  Set the absolute X coordinate and Y coordinate (40000, 50000) in the instruction  Point A is the present position, SR460=10000 and SR480=10000  S 3 is 1 and the clockwise circle is drawn with 5 ° as the basic motion angle.  When the PLC runs the program and M0 is ON, the absolute-position circle drawing starts. 6_ 4. Operation:  When the PLC runs the program and M0 is ON, the PLC starts to draw the circle in the clockwise direction at 100 kHz.  When the circle drawing completes, SM461 and SM481 are ON.

6-849 O A O (40000, 50000) A (10000, 10000)