DVP-ES3 Series Programming Manual Symbol S : The first output number in the position planning table D 1 : The output number that is being output D 2 : Switch flag at the end of the consecutive-number output _6 Explanation: 1. This instruction uses the position planning table to control the output. S is the number listed in the position planning table. If the number does not exist in the table, the instruction is not executed, SM0 is ON and the error code is SR0=16#2027. 2. S is the first output number when PLC runs. Refer to the value in D 1 if there are consecutive-number outputs during the output. 3.
When one single number or the first one of consecutive numbers is output, the switch flag D 2 is set to OFF. When the consecutive-number output reaches the output number to be switched to, D 2 is ON for a scan cycle and then is ON again until the last number output is completed. 6-850 API Instruction Operand Description 2718 TPO S,D1,D2 Position planning table controls the output Device X Y M S T C HC D FR SM SR E K 16# “$” F S D1 D2 BOOL WORD DWORD LWORD UINT INT DINT LINT REAL LREAL TMR CNT STRING Data type S D1 D2 Pulse Instruction 16-bit instruction 32-bit instruction - ES3 -