DVP-ES3 Series Programming Manual Example 2: Use global symbol or D device in Target Position 1. Use D device in Target Position of the position planning table and download the parameters. The unit for D60 in PLC is pulse by default. If you need to use D devices in Target position and in the mechanical unit, you need to convert the mechanical unit to pulse. 2. When M0 is ON, and D60 is 400,000. Y0 outputs 400,000 pulses at 100kHz. After the output completes, M100 is ON. Note: the unit is pulse, when you use global symbols, D devices, or instructions including DTPWS, DTPWL, and DTPWC to input values in in Target Postion. _6 3. If global symbols are used in Target Position A.
You need to assign an address for the global symbol. B. Use global symbols in Target Position of the planning table. 6-852