Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions Explanation 1. This instruction causes the machine to return to the zero point. The range of the target frequency ( TFreq ) for zero return is between 1 Hz–200 kHz. The JOG frequency ( JFreq ) should be less than the target frequency ( TFreq ). The JOG frequency ( JFreq ) is the start frequency. If the target frequency ( TFreq ) is less than ( JFreq ), the target frequency ( TFreq ) is automatically revised processed as equal to ( JFreq ) . 2. Do not change the operands DOG, NL, Pulse, or Dir during instruction execution. The input point for DOG and NL is suggested to use the 16 high-speed input points X0–X7 and X10–X17.

They will not be affected by PLC instruction scan time. If you use X20 successive input points or M devices, they will be affected by the PLC instruction scan time. 3. See the below descriptions for DOG, NL and Dir. 4. See the below SR and SM table for pulse outputting. 6_ 6-867 DOG point You can use X or M device but do NOT choose the same input point for different axis. When the DOG point uses X0–X7 and X10–X17 for inputs, go to HWCONFIG to set up the filtering time for the inputs if the switch starts to rattle. NL point You can use X or M device but do NOT choose the same input point for different axis.

Dir contact You can use Y or M device but do NOT choose the same input point for different axis. Pulse output points Y0 Y2 Y4 Y6 Setting up the time for directional outputting SR640 SR642 SR644 SR646 goes first before pulse outputting (unit: 1 ms) Busy flag SM460 SM480 SM500 SM520 Completion flag SM461 SM481 SM501 SM521 Present output position SR460 SR461 SR480 SR481 SR500 SR501 SR520 SR521 Pulse output points Y1 Y3 Y5 Y7 Setting up the time for directional outputting SR641 SR643 SR645 SR647 goes first before pulse outputting (unit: 1 ms) Busy flag SM472 SM492 SM512 SM532 Completion flag SM473 SM493 SM513 SM533 Present output position SR474 SR475 SR494 SR495 SR514 SR515 SR534 SR535