Chapter 6 Applied Instructions 6.27 Delta CANopen Communication Instructions 6.27.1 List of CANopen Communication Instructions The following table lists the High-speed Output instructions covered in this section.
6_ 6-873 Instruction code Pulse Delta specific API Function 16-bit 32-bit instruction Servo Inverter 2800 INITC – – Initializing the servo for CANopen communication V V 2801 ASDON – – Servo-ON and Servo-OFF V V 2802 CASD – – Setting the acceleration time and deceleration time for a servo V V 2803 – DDRVIC – Servo relative position control V – 2804 – DDRVAC – Servo absolute position control V – 2805 – DPLSVC – Servo speed control V V 2806 ZRNC – – Servo homing V – 2807 COPRW – – Reading and writing CANopen communication data V V 2808 COPWL DCOPWL – Writing multiple CANopen parameter values V V 2809 RSTD – – Sending Reset or NMT command V V 2810 ZRNM – – Setting the homing mode for Delta servo V – 2811 EMER – – Reading Emergency message V V 2812 – DCSFOC – Controlling the tracking function of a servo via communication V –