Delta DVP-ES3 — 6.19.2 Explanation of Communication Instructions

DVP-ES3 Series Programming Manual Example 2 Slave Mode Using the CANRS instruction, the received data from the master are stored in the devices starting from D120 and the 8-byte data in D20~D27 are sent back. M110 changes to On when the sending and receiving are over. See the explanation of relevant parameters. _6 1. As M1 is on, set the MsgID of the sent message to 2 and MsgID of the received message to 1 and then wait to receive data. A. The received 6-byte data from the master are placed in D120~D127. B. Then the 8-byte data in D20~D27 start to be sent back to the master. M110 changes to On as the data sending is done.

6-602 Slave mode MsgID=1 _ Communication mode 2= Slave mode, sends data after receiving data. Communication ID MsgID of the sent message, D0=2 Sent-data length 8 BYTE Starting device where D20 sent data are stored Starting device where received data are stored D120 for storing MsgID D121 for storing the number of received packets D122…. for storing received data Communication M110 completion flag Communication error flag M111 Device D120 D121 D122~D127 Content 1 6 H0A Device D10~D15 Content H0B (Defined by users)