Chapter 6 Applied Instructions Setting the communication format for a serial communication port 6_ *1: You can set the baud rate in HWCONFIG in ISPSoft. The data transmission speed is listed in the following table.
6-611 b0 Data length 7 (value=0) 8 (value=1) Parity bits 00 : None b2-b1 01 : Odd 10 : Even b3 stop bits 1 bit (value=0) 2 bits (value=1) 0001 (16#1) : 4800 0010 (16#2) : 9600 0011 (16#3) : 19200 0100 (16#4) : 38400 0101 (16#5) : 57600 b7-b4 0110 (16#6) : 115200 0111 (16#7) : 230400 Not available for RS-232 1000 (16#8) : 500000 Not available for RS-232 1001 (16#9) : 921000 Not available for RS-232 1111 (16#F) : Self-defined*1 b8-b15 Undefined (reserved) Baud rate (bps) RTU timeout timer (ms) Baud rate (bps) RTU timeout timer (ms) 4800 9 115200 1 9600 5 230400 1 19200 3 - - 38400 2 - - 57600 1 - -