7 Application Instructions API 50-99 5. Flags and special registers for EH2/SV/EH3/SV2 series MPU: Functions in EH series MPU: 1. Relevant devices for EH/EH2/SV/EH3/SV2 series MPU: X0 2. The range of pulse speed for this instruction is 10 ~ 200,000Hz. If the set values of maximum speed and acceleration/deceleration time exceed the range, PLC will operate by the default value that is within the range. DVP-PLC APPLICATION MANUAL 7-41 M1257 The acceleration/deceleration slope of the high-speed pulse output is an S curve. M1308 Off->On: The high-speed output of the first pulse CH0 (Y0, Y1) paruse immediately. On->Off: Continue to output the pulses which have not been output. M1309 Off->On:
The high-speed output of the first pulse CH1 (Y2, Y3) paruse immediately. On->Off: Continue to output the pulses which have not been output. M1310 Off->On: The high-speed output of the first pulse CH2 (Y4, Y5) paruse immediately. On->Off: Continue to output the pulses which have not been output. M1311 Off->On: The high-speed output of the first pulse CH3 (Y6, Y7) paruse immediately. On->Off: Continue to output the pulses which have not been output. M1347 For EH2/SV/EH3/SV2 (V1.4 and later versions). Reset flag for CH0 pulse output M1348 For EH2/SV/EH3/SV2 (V1.4 and later versions). Reset flag for CH1 pulse output M1524 For EH2/SV/EH3/SV2 (V1.4 and later versions).
Reset flag for CH2 pulse output M1525 For EH2/SV/EH3/SV2 (V1.4 and later versions). Reset flag for CH3 pulse output D1127 The number of pulses at the acceleration setion for the position instruction (low word) D1128 The number of pulses at the acceleration setion for the position instruction (high word) D1133 The number of pulses at the deceleration setion for the position instruction (low word) D1134 The number of pulses at the deceleration setion for the position instruction (high word) PLSR K1000 D10 K3000 Y0 Operand S 1 S 2 S 3 D Explanation Max.
frequency Total number of pulses Accel/Decel time Output point Range 16-bit 10 ~ 32,767Hz 110 ~ 32,767 1 ~ 5,000ms Y0 ~ Y7 32-bit 10 ~ 200kHz 110 ~ 2,147,483,647 Definition K0: No output Kn: Designated frequency Kn: Designated number Flag: M1067, M1068 See settings of D1220, D1221