9 Application Instructions API 150-199 last two bits; other bits are invalid. 1. K0: Y4 output 2. K1: Y4, Y5 AB-phase output; A ahead of B. 3. K2: Y4, Y5 AB-phase output; B ahead of A. 4. K3: Y5 output D1230: For EH2/SV/EH3/SV2, phase setting of CH3 (Y6, Y7): D1230 determines the phase by the last two bits; other bits are invalid. 1. K0: Y6 output 2. K1: Y6, Y7 AB-phase output; A ahead of B. 3. K2: Y6, Y7 AB-phase output; B ahead of A. 4. K3: Y7 output D1336: For EH/EH2/SV/EH3/SV2, low word of the current number of output pulses from CH0. D1337: For EH/EH2/SV/EH3/SV2, high word of the current number of output pulses from CH0. D1338:
For EH/EH2/SV/EH3/SV2, low word of the current number of output pulses from CH1. D1339: For EH/EH2/SV/EH3/SV2, high word of the current number of output pulses from CH1. D1340: For EH/EH2/SV/EH3/SV2, settings of the first start frequency and the last end frequency of CH0. D1343: For EH/EH2/SV/EH3/SV2, settings of acceleration/deceleration time for CH0 pulse output. D1348: For EH2/SV/EH3/SV2, deceleration time for CH0 pulse output when M1534 = On. D1350: For EH2/SV, deceleration time for CH2 pulse output when M1536 = On. D1349: For EH2/SV, deceleration time for CH1 pulse output when M1535 = On. D1351: For EH2/SV, deceleration time for CH3 pulse output when M1537 = On. D1352:
For EH/EH2/SV/EH3/SV2, settings of the first start frequency and the last end frequency of CH1. D1353: For EH/EH2/SV/EH3/SV2, settings of acceleration/deceleration time for CH1 pulse output. D1375: For EH2/SV/EH3/SV2, low word of the current number of output pulses from CH2. D1376: For EH2/SV/EH3/SV2, high word of the current number of output pulses from CH2. D1377: For EH2/SV/EH3/SV2, low word of the current number of output pulses from CH3. D1378: For EH2/SV/EH3/SV2, high word of the current number of output pulses from CH3. D1379: For EH2/SV/EH3/SV2, settings of the first start frequency and the last end frequency of CH2. D1380:
For EH2/SV/EH3/SV2, settings of the first start frequency and the last end frequency of CH3. D1381: For EH2/SV/EH3/SV2, settings of acceleration/deceleration time for CH2 pulse output. D1382: For EH2/SV/EH3/SV2, settings of acceleration/deceleration time for CH3 pulse output. D1383: For EH2/SV/EH3/SV2, the time difference between the direction signal and pulse output sent by CH2. D1384: For EH2/SV/EH3/SV2, the time difference between the direction signal and pulse output sent by CH3. DVP-PLC Application Manual 9-56