DVS Series Managed Industrial Ethernet Switches User’s Manual An SNMP agent sends SNMP trap messages to the trap community (trap receiver). It monitors the switch for particular events or conditions, and generates trap messages based on these events or conditions. Trap Configuration 3.2.1.3 Trap Flags After you configure the trap communities, you also need to configure what kinds of SNMP traps the switch can generate and send. When the switch detects the active trap which is an identified condition, a trap will be sent to the trap communities. 3-34 Description Factory Default Community Name Enter a case-sensitive string. The maximum length is 16 characters. Maximum trap is 10.
None Version Specify the SNMP version that is used for the trap community: SNMP V1: Uses SNMPv1 to send traps to the trap community. SNMP V2: Uses SNMPv2 to send traps to the trap community. None Protocol Specify the IP version that is used for the trap community: IPv4: Sends traps to an IPv4 address. Input an IPv4 address in the Address field. IPv6: Sends traps to an IPv6 address. Input an IPv6 address in the Address field. None Address Enter an IPv4 or IPv6 address according to the selection in the Protocol drop-down list. For an IPv6 address, enter the address as xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx format. None