EA180 Series Servo Drive Users Manual * This parameter will be stored and the drive will be enabled ON immediately upon the next power-on. If this is not desired, please modify this parameter value to 0 before power-off. 75 value yb denimreted si emit ced/cca eht dna ,00-8P yb denimreted si noitarepo goj fo deeps ehT * go gojs- yalpsid ,citats si rotom ,yek eht sserp ton oD . gojs_ syalpsid ti dna ylesrever snur rotom eht , ˅ sserP . gojs syalpsid ti dna drawrof setator rotom eht , ˄ sserP _ - -sj P8-01. _ * Please operate in the . prdy (not enabled, and ready) state, and the jog process will automatically exit if a warning occurs. Data size 16bit Commu. addr.
3F03H Internal S ON command Register value storage Saved _ Register value Dis play Operation 0 Press S to display -End- . If there is no other enable input, the drive will enter the 0 enable OFF state. AF-03 1 s- If the enable condition is met, press S to display s-on , and the drive will enter the on enable-ON state. Data size 16bit Commu. addr.
3F04H FFT test Register value storage Auto reset upon completion Register value Disp lay Operation 0 0 Press S , it displays -End- , no operation AF-04 1 Eyd Press S , and it displays Eydft and carries out speed bandwidth test with the upper ft device software identification system; after the test, automatically exit and upload the data to the upper device for analysis and display. * The motor has slight vibration and sound. Data size 16bit Commu. addr.
3F05H Offline inertia identification Register value storage Auto reset upon completion Register value Dis play Operation 0 0 Press S , it displays -End- , no operation AF-05 1 jI Press S , it displays jIdt and starts to identify the current system inertia. After successful identification, the inertia (multiple of the motor inertia) is automatically stored in dt P4-10. * Refer to Section 6.6 for detailed description of inertia identification. Data size 16bit Commu. addr.
3F06H AI channel self-correction Register value storage Auto reset upon completion Register value Dis play Operation 0 0 Press S , it displays -End- , no operation 1 A The given AI1 external voltage source is 0V (the actual voltage may not be 0V); press S , it I1 displays AI1 and carries out zero drift learning, and the results will be automatically AF-06 stored in P6-33 after completion. 2 A The given AI2 external voltage source is 0V (the actual voltage may not be 0V); press S , it I2 displays AI2 and carries out zero drift learning, and the results will be automatically stored in P6-34 after completion.