Driver Assist Features Caution The dynamic environment simulation display can only be used as a reference and cannot perfectly reflect the real traffic conditions. Therefore, do not rely on the dynamic environment simulation display. Overtaking Assist provided by Adaptive Cruise Control When the vehicle is in following mode under Adaptive Cruise Control, if you turn on the left turning signal and steer the steering wheel in an attempt to overtake another vehicle, it will activate acceleration assist to accelerate up to the set cruising speed. Overtaking Assist can be activated when:
• Adaptive Cruise Control is active and has detected a vehicle traveling in the same direction ahead • The current vehicle speed is higher than 50 km/h, but not over the set cruising speed • There is no lane marking or the lane marking is a dashed line on the side where the lane change is • The vehicle is at a safe distance from the vehicle ahead • The hazard warning light is not on • No malfunction with the turning signal When the above conditions are met, you can activate Overtaking Assist by moving the left turning signal lever to the bottom.
When you turn the steering wheel to the left, Adaptive Cruise Control will maintain the distance between itself and the vehicle ahead, but will allow you to drive slightly closer than the set following distance. During a lane change, Adaptive Cruise Control will accelerate up to the set cruising speed without you stepping on the accelerator pedal. Caution Your vehicle may decelerate when Overtaking Assist is in operation due to the lead vehicle in the current or target lane, which is highlighted on the digital instrument cluster. Overtaking Assist function will be deactivated, but Adaptive Cruise Control will remain active, when: 289