EWM1000plus EWM2000evo EWM3000new 2.9 Phases of the diagnostics test Independently of the type of selector, after activating the diagnostics system, the operation diagnostics of the different components and the reading of the alarms can be performed, by rotating the selector clockwise . In models with digit the code of the selector position is displayed for a second. In the diagnostics cycle all alarms are activated. If during the cycle operation an alarm occurs, the appliance blocks and the LEDs (and the display) flash indicating the relative code.
QUICK GUIDE AND APPLIANCES LIST 24/176 599 72 40-80 Diagnostics phases Selector Only pushbutton Components actioned Operating conditions Function checked Displayed parameters (1) 1 All the LEDs light in sequence.
When a button is pressed, the corresponding LED lights (and the buzzer, if featured, sounds) Always activated Operation of the user interface Button codification 2 Door interlock Washing solenoid Door locked Water level below anti-flooding level Maximum time 5 minutes Water ducted through washing compartment (**)Selection position code 3 Door interlock Pre-wash solenoid Door locked Water level below anti-flooding level Maximum time 5 minutes Water ducted through pre- wash compartment (bleach) (**)Selection position code 4 Door interlock Pre-wash and wash solenoids Door locked Water level below anti-flooding level Maximum time 5 minutes Water ducted through conditioner compartment (**)Selection position code 5 Door interlock.
Bleach/stains solenoid. Door locked Water level below anti-flooding level Maximum time 5 minutes Water ducted through bleach/stains compartment (**)Selection position code 6 Door interlock Washing solenoid if the level of water in the tub is below 1st level Heating element. Door locked. Water at 1st level. Maximum time 10 min. or up to 90ºC. (*) Heating (**)Selection position code 7 Door interlock. (Washing solenoid if the level of water in the tub is below 1st level). Motor (55 rpm clockwise, 55 rpm counter-clockwise, 250 rpm impulse) Door locked Water level at 1st level.
Check for leaks from the tub (**)Selection position code 8 Door interlock Drain pump Motor up to 650 rpm then at maximum spin speed Door locked Water level lower than anti-boiling level for spinning Drain and spin; control of congruence in closure of level pressure switches (**)Selection position code 9 Drying heater Fan Condensation solenoid Drain pump Motor Door closed Drying (**) selector position code