11 DRYING CIRCUIT 1. Fan 2. Fan motor 3. Drying heater 4. Heater casing 5. Duct 6. Door seal 7. Tube from tub to condenser 8. Condenser 9. Water fill solenoid 10. Condenser water intake and steam vent tube 11. Solenoid tube-airbreak 12. Coupling (Air-break) 13. Filter body 14. Drain pump Automatic drying cycles : the drying time is governed by the microprocessor so that the desired degree of dryness is achieved. The drying cycle can be performed at the end of the washing cycle, or as a separate programme. Various types of drying can be selected: - extra-dry - cupboard-dry - iron-dry Time-controlled cycle :
the drying time is selected by the user (maximum 130 minutes for cotton and synthetic fabrics). Cooling : a cooling cycle is performed at the end of every drying cycle . Anti-crease: after the cooling phase an anti-crease phase of a 10-minute duration is performed. The drying heaters are powered directly by the main board via two relays . In cycles for synthetic fabrics, drying is performed with only one heater switched on (half power); in cotton/linen cycles, both the heaters are switched on (full power). The fan motor is powered via a relay; the condensation solenoid is powered by a triac . The washing of the condenser occurs at the beginning of the last rinse.
SOI/DT 2007-11 dmm 51/69 599 70 39-88