11.1 Temperature control The drying temperature is controlled by an NTC sensor positioned on the duct. The heater casing features two safety thermostats (one of which is a manual-reset type). 1. Circuit board 2. Anti-boiling pressure switch AE1 3. Safety thermostat (auto-reset) 4. Drying heater 5. Safety thermostat (manual reset) 6. Anti-boiling pressure switch AE2 7. Fan motor 8. Drying control sensor (NTC) 9. Humidity control sensor (NTC) Calculating the drying time: In automatic cycles, the NTC sensor fitted to the drying duct is used to calculate the drying tim . 1. NTC temperature sensor 2. Tube from tub to condenser 3. Drying condenser SOI/DT 2007-11 dmm 52/69 599 70 39-88 1.
Drying temperature control thermostat (NTC) 2. Safety thermostat (auto reset) 3. Manual-reset safety thermostat (150°C) 4. Drying heater NTC sensor: resistance at 25°C 5000Ω Manual-reset safety thermostat Normally closed Opens at 150°±5°C Auto-reset safety thermostat Normally closed Opens at 110°±3°C Closes at 94°±5° Heater group Power 920+920 W Voltage 230V 240V Resistance 56,5Ω+56,5Ω 61,5Ω+61,5Ω Fan capacity 80 m3 – hour