5.3 Rapid reading of alarm codes The last three alarm codes can be displayed even if the programme selector is not in the tenth position (diagnostics) or if the appliance is in normal operating mode (e.g. during the execution of the washing programme): Press and hold down START/PAUSE and the nearest option button (as to enter the DIAGNOSTICS), for at least two seconds: the LEDs initially switch off, and then display the flashing sequence indicating the last alarm. To display the previous alarms press the left button of the START/PAUSE button sequentially. To return to the last alarm, press the START/PAUSE button. The alarm sequence continues as long as the two buttons are held down.
The alarm reading system is as described in paragraph 5.2.1. While the alarms are displayed, the appliance continues to perform the cycle or, if in the programme selection phase, maintains the previously-selected options in memory. 5.4 Cancelling the last alarm It is good practice to cancel the last alarm: after reading the alarm code, to check whether the alarm re-occurs during diagnostics; after repairing the appliance, to check whether it re-occurs during testing. N.B. With this operation all the memorised alarms are deleted. 2007-10 SOI/DT-mdm FCPD-dp Quality-fz 13/59 599 70 32-47 1. Select diagnostic mode and turn the programme selector to the tenth position (reading of alarms). 2.
Press and hold down START/PAUSE and the nearest option button (as represented in figure). 3. Hold down the buttons till the LEDs stop to flash (at least 5 seconds).