External Discharging ● Unplug the discharging device. ● Close the charge port cap and the port door (see instructions for Mode 2 charging). Starting discharging ● Before discharging, disarm the anti- theft alarm system. ● Organizing the equipment: ● Unlock the charge port door switch, then open the port door and cap. ● Store the equipment properly when discharging is complete. ● Check before discharging: ● Ensure that the battery capacity of the vehicle to be discharged is not below 15%. Battery ● Ensure the V2L connection device casing is not cracked, and its plug is free from rust or obstructions.
High-Voltage Battery ● The vehicle is powered by a high- voltage battery that can be charged and discharged repeatedly. The high- voltage battery is charged by an external power source or through energy recovery when the vehicle brakes or coasts. ● Ensure that there is no water or foreign material inside the charge port and that metal terminals are not damaged and free from rust or corrosion. ● Do not discharge if abnormalities as described in the second or third condition are found; otherwise, short circuit or electric shock so caused could lead to personal injury.
● The high-voltage battery is located under the vehicle floor, so be careful to avoid bumping when driving on bumpy or uneven roads. ● Connect the discharge connection device: Battery Properties ● Connect the V2L discharge device to the charge port. The power strip indicator lights up when the strip is powered and ready for use. ● It is normal that vehicle performance is affected by battery electrochemical properties and self-protection and varies to some extent in the following conditions: ● Discharging starts: ● When SOC is high, the regenerative braking performance may decline.
● After the connection is made, discharging begins and respective information is displayed on the instrument cluster. ● The vehicle switches to trickle charging mode at high SOC. If the charging time is prolonged, the estimated remaining charging time displayed on the instrument cluster may not be accurate. Stopping discharging ● Stop discharging: ● Disconnect the load. ● When SOC is low, the acceleration performance may decline. ● Disconnect the discharge connection device: 82