EM500 Open-Loop Vector Control Inverter User Manual CANSinee protocol communication, Communication timeout setting, See the Modbus Communication Timeout function explanation For the PLC or HMI with inverter after equipment debugging is completed, set F10.56 = 11, then all write data isn’t stored; PLC communication can avoid writing EEPROM. If parameters should be saved after power off please setting F10.56 = 0. 7.12 F11 Group: User-Defined Parameter First, by setting F11, user may select a function code and enter the user-defined mode (--U--, see 4.2.2). Through and , user may switch to the desired function code circularly.
This function is mainly applied to occasions of less than 32 function codes so as to avoid troubles of too many function codes. 261 No. Function Range Unit Default Type CANSinee 0.0 - 60.0, 0.0: Disabled (also F10.55 Communication s 0.0 ● works for master - slave system) timeout No. Function Range Unit Default Type F10.56 RS485write EEPROM 0~10:default for debugging 11: No trigger write before debugging 0 〇 No.
Function Range Unit Default Type F11.00 User-Defined Parameter 1 U00.00 ● F11.01 User-Defined Parameter 2 U00.01 ● F11.02 User-Defined Parameter 3 U00.02 ● F11.03 User-Defined Parameter 4 U00.03 ● F11.04 User-Defined Parameter 5 U00.04 ● F11.05 User-Defined Parameter 6 U00.07 ● F11.06 User-Defined Parameter 7 U00.14 ● F11.07 User-Defined Parameter 8 U00.15 ●