sinee — 7.13 F12 Group: Keypad and Display Parameter

EM500 Open-Loop Vector Control Inverter User Manual F00.00. The switching sequence of the function codes under the user-defined mode set by F11.00=U00.00, means that the first user-defined parameter is the function code the keypad shall be the sequence set by the function codes F11.00 - F11.31. 7.13 F12 Group: Keypad and Display Parameter M.K is a multifunction key. By setting the function code F12.00, its actual function will be realized. If F12.00=0, this function does not work; if F12.00=Any other value, press this key to realize corresponding function.

According to the setting of the function code F00.02 (command source options), the command source has three control types, keypad control, terminal control and communication control, i.e., if the terminal control is selected as the command source, the buttons RUN and STOP RESET of keypad will be disabled. However, in emergency, user 263 F11.28 User-Defined Parameter 29 F11.29 User-Defined Parameter 30 F11.30 User-Defined Parameter 31 F11.31 User-Defined Parameter 32 U19.04 ● U19.05 ● U19.06 ● U19.12 ● No. Function Range Unit Default Type F12.00 M.K 0: No Function 1: Forward JOG 2: Reverse JOG 3: Forward/Reverse Switch 4: Rapid Stop 5: Coast to Stop 6: Cursor Left Shift 1 〇 No.

Function Range Unit Default Type F12.01 STOP 0: Valid Only at Keypad Control 1: Valid at All Command Channels 1 〇