sinee — 7.20 F19 Group: Fault Record Parameter

EM500 Open-Loop Vector Control Inverter User Manual 7.20 F19 Group: Fault Record Parameter This group of parameters can be used for viewing the types of the last three faults and the status of inverter at fault, but cannot be operated.  Function codes related to the information about the last fault: 307 high-speed pulse input channel HDI (X7). See F16.03 and F16.04. Range: 0 - F16.03. F18.34 Actual Length Used to display the actual length of the workpiece being processed (by transformation from HDI (X7) as per relevant setting) of input pulses of present high-speed pulse input channel HDI (X7). See F16.01 and F16.02. Range: 0 - F16.01.

m F18.35 Remaining Time of Timed Run Used to display the remaining time of the timed run. See F16.05. Range: 0.0 - F16.05. min F18.36 Position of Rotor of Synchronous Motor Position of rotor of synchronous motor. Range: 0.0 - 359.9. ° F18.37 Rotary Transformer Position Used to display the rotary transformer position. Range: 0 - 4095. F18.38 Motor Temperature Used to display motor temperature collected by the analog channel 4 (AI4). Range: 0 - 200. ℃ F18.39 VF Separation Target Voltage Used to display VF separation target voltage in real time. Range: 0.0 - Motor Rated Voltage. V F18.40 VF Separation Output Voltage Used to display VF separation output voltage in real time. Range:

0.0 - Motor Rated Voltage. V F18.41 - F18.50 Not Used -100.0 ~ 100.0 F18.51 PID Output In zero servo running status, this function code is used to display present position offset. Range: -0 - 65535. % F18.60 Inverter temperature Temperature of inverter module ( it is normal that the temperature is higher than the environment for 40) - 40 ~ 200 ℃ No. Function Range Unit Default Type F19.00 Last Fault Type Display the last fault type. See Table 7-22 Fault Types 0 × F19.01 Output Frequency Used to display output frequency Hz 0.00 ×