EM500 Open-Loop Vector Control Inverter User Manual The above parameters are used for multiple preset pressure water supply timing and setting the corresponding pressure (effective on the conventional day). 7.23 F27 Winding rolling application F27.00=0: Winding mode This mode can realize the winding function. After the factory setting is restored, the parameters will be reverted to the winding specific parameters F27.00=1:Unwinding mode This mode can realize the unwinding function. After the factory setting is restored, the parameters will be reverted to the unwinding specific parameters F27.00=2:Wire drawing mode This mode can realize the wire drawing function.
After the factory setting is restored, the parameters will be reverted to the wire drawing specific parameters F27.00=3:Straight wire drawing machine mode This mode can realize the Straight wire drawing machine mode function. After the factory setting is restored, the parameters will be reverted to the Straight wire drawing machine mode specific parameters 323 F26.23 T3 Start Pressure F25.03~F25.02 % 0.1 〇 F26.24 T4 Start time T3~23.59 0.00 〇 F26.25 T4 Start Pressure F25.03~F25.02 % 0.1 〇 F26.26 T5 Start time T4~23.59 0.00 〇 F26.27 T5 Start Pressure F25.03~F25.02 % 0.1 〇 F26.28 T6 Start time T5~23.59 0.00 〇 F26.29 T6 Start Pressure F25.03~F25.02 % 0.1 〇 No.
Function Range Unit Default Type F27.00 The application of macro 0: Winding mode 1:Unwinding mode 2:Wire drawing mode 3:Straight wire drawing machine mode 0 〇 3:Straight 0: 1:Unwindin 2:Wire wire Winding No Explain g mode drawing mode drawing mode machine mode After setting F 16.00 = 3, and choose the macro, restore factory settings. The application parameters are automatically set to the following default values.