EM500 Open-Loop Vector Control Inverter User Manual 8. Motor Parameter Autotuning 8.1 Motor Parameter Autotuning When inverter is in vector control mode, motor parameter autotuning is required. However, if not, parameter autotuning is also suggested for acquiring higher control precision at initial operation. It’s not easy for user to obtain motor parameters required for the arithmetic at vector control. EM500 provides the function of motor parameter autotuning. After the function is enabled, inverter autotunes the relevant parameters of motor connected and saves them to the internal memory.
For definitions of motor parameters, please refer to Figure 8-1 for specific meanings of 3-phase induction motor. R1 L1-Lm R2 L2-Lm I1 I2 (1-s)/s*R2 U1 I0 Lm Figure 8-1 Equivalent Circuit of 3-Phase Induction Motor In the figure, meanings of R1, R2, L1, L2, Lm and I0: Stator resistor, rotor resistor, stator inductance, rotor inductance, stator & rotor mutual inductance, and idling excitation current respectively; leakage inductance Ls=L-Lm. 8.2 Precautions Before Autotuning Autotuning is a process of autotuning motor parameters. EM500 can autotune motor parameters in 2 modes: stationary autotuning and rotational autotuning.
Stationary autotuning is applied to the occasions when motor can not be disconnected from load, but inverter can obtain motor parameters. 352