EM500 Open-Loop Vector Control Inverter User Manual DLC data length codes, in the range 0 to 8, which can also be transmitted on the bus when the DLC value is greater than 8 The number of bytes transferred in the data field for this frame is still limited to 8 bytes. The data segment consists of 0 to 64 bits and contains the actual valid information (0-8 bytes) for this frame transmission. The data segment is followed by a CRC segment consisting of a 15-bit CRC sequence and a 1-bit CRC delimiter. The receiver may use the CRC sequence to identify whether or not erroneous data has been accepted. The acknowledgment segment consists of an acknowledge slot bit and an acknowledge delimiter bit.
The transmitter transmits a recessive level at the acknowledge slot; after receiving the complete message correctly, the receiver sends a dominant level for acknowledgment. By the end of the frame composed of seven recessive level. 13.3.2 Protocol content In the standard frame of a frame of data, users only need to focus on the contents of the identifier , control section and the data segment . The definition data format is as follows: The 11-bit identifier consists of a 4-bit function code and a 7-bit node address. The node address ranges from 0 to 127, where 0 is the broadcast address. 127 for the host address, the specific function code is defined in the table below.
413 Identifier Control Data Field(16bit) Domain Function code + slave address Data length Data 1 Data 2 Data 3 Data 4 Function Function Abnormal CAN - ID range code code (point-to-point)