EM600 High-Performance Vector Control Inverter User Manual Refer to corresponding manuals of communication expansion cards. For application of PLC/HMI + inverter, after the adjustment is completed, if F10.56=11 PLC communications written data is not stored in order to avoid writing memory error problem. If you need to set parameters and require power off storage you can set F10.56=0 before operation. 7.12 F11 Group: User-Defined Parameter Keypad of EM600 inverter supports user-defined mode. First, by setting F11, user may select a function code and enter user-defined mode (--U--, see 4.2.2). Through , user may switch to desired function code circularly.
This function is mainly applied to occasions of less than 32 function codes so as to avoid troubles of too many function codes. and 200 received F10.50 number of process data transmission 1~16 2 ● F10.51 Process data address setting mode selection 0:keypad 1:Master 0 ● F10.52 Communication card manual reset selection 0:disable 1:enable 0 ● Function Code Name of Function Code Parameter Description Unit Default Property F10.56 RS485Write EEPROM 0~10:default for debugging 11:
No trigger write before debugging 0 〇 Function Name of Function Parameter Description Unit Default Property Code Code F11.00 User-Defined Parameter 1 U00.00 ● F11.01 User-Defined Parameter 2 U00.01 ● F11.02 User-Defined Parameter 3 U00.02 ● F11.03 User-Defined Parameter 4 U00.03 ● F11.04 User-Defined Parameter 5 U00.04 ● F11.05 User-Defined Parameter 6 U00.07 ● F11.06 User-Defined Parameter 7 U00.14 ● F11.07 User-Defined Parameter 8 U00.15 ● F11.08 User-Defined Parameter 9 U00.16 ●