User Manual of EM730/EM730E Series Inverter increase. When the PWM modulation mode is invalid (F15.36=0), the 7-segment PWM modulation will be enabled. When the WM modulation mode is valid (F15.36=1), the 7-segment PWM modulation will be enabled at the output frequency lower than the switching frequency (F15.37) and the 5-segment PWM modulation will be enabled at the output frequency higher than the switching frequency. The 7-segment PWM modulation has a smaller current ripple than 5-segment PWM modulation, but involves larger switching loss, more heat from the inverter, and larger temperature rise.
This parameter does not need to change under normal circumstances in the dead zone compensation mode. Users need to select a different compensation mode only in case of special requirements for the quality of the output voltage waveform or other abnormalities (e.g. motor oscillation). The compensation mode 1 is often selected. If the motor is prone to oscillation at high power and under VF control, the compensation mode 2 may be selected. In the terminal control mode (F00.02=1), this function code is used to set the highest priority of the jog command.
If the terminal jog priority is valid (F15.39=1), the running status can be switched to jog running in the presence of a valid jog terminal; and if the terminal jog priority is invalid (F15.39=0), the running status cannot be directly switched to jog running. 264 Function Default Function code name Parameter description Unit Attribute code setting F15.36 Switching options of PWM modulation mode 0: invalid (7-segment PWM modulation) 1:
valid (5-segment PWM modulation) 0 〇 F15.37 Switching frequency of PWM modulation mode 0.00 to maximum frequency F00.16 Hz 15.00 ● Default Function code Function code name Parameter description Unit Attribute setting F15.38 Options of dead zone compensation mode 0: no compensation 1: compensation mode 1 2: compensation mode 2 1 〇 Function code Default setting Function code name Parameter description Unit Attribute F15.39 Terminal jog priority 0: Invalid 1: valid 0 〇