User Manual of EM730/EM730E Series Inverter Different types of protection of EM730/EM730E series inverters are explained in Table 7-24. Table 7-24 List of Protection Types 281 F19.14 Output current in protection Display the output current of the previous two protections. A 0.00 /0.0 × F19.15 Bus voltage in protection Display the bus voltage of the previous two protections. V 0 × F19.16 Operating status in protection Display the running status of the previous two protections, as detailed in Table 7-25 List of Running Statuses during Protection. 0 × F19.17 Working time in protection Display the working time of the previous two protections.
h 0 × Protection Type Keyboard Protection Type Keyboard display display 0: No protection 0 E01: output short circuit protection E01 E02: instantaneous overcurrent E02 E03: reserved E03 E04: steady-state overcurrent E04 E05: steady-state overvoltage E05 E06: Steady-state undervoltage E06 E07: input phase loss E07 E08: output phase loss E08 E09: inverter overload E09 E10: inverter overheat protection E10 E11: parameter setting conflict E11 E12:retention E12 E13: motor overload E13 E14: External protection E14 E15: Inverter memory protection E15 E16: communication abnormality E16 E17: Temperature sensor abnormality E17 E18: disengaged soft start relay E18 E19:
current detection circuit abnormality E19 E20: Stall protection E20 E21: PID feedback disconnection E21 E20: retention E22 E23: Keyboard memory protection E23 E24: parameter identification abnormality E24 E25: retention E25 E26: off-load protection E26 E27: up to the cumulative power-on time E27 E28: up to the cumulative running time E28 E29: Internal communication protection E29 E44: Cable protection E44 E43: Material cutoff protection E43