Emco Compact 5 PC — Emco Compact 5 PC CNC Lathe Software Description & User Manual PDF

Description 1 1 2 3 4 5 6 2 5 9837 10 4 of the Machine 1 6 10 Machine bed Chip container Longitudinal slide Cross slide Headstock Tailstock 7 8 9 10 11 2 4 l 3 | alo @ a ae Base for toolholder Toolholder Chip protection device Stepping motor Switch board Key switch (1) At position 1 of the Main spindle switch (4) key switch the machine is ready for operation (pilot lamp (2) lights up); Main and feed motors are supplied with power. Note: To protect the machine against unauthorized starting, the key should always be taken off. Emergency-off key with locking (3) Upon actuation the power supply to main and feed motors is interrupted (pilot amp (2) lights up). Unlocking:

Turn button in clockwise direction. The main spindle switch only remains in position 1 (main motor runs) if the key switch is in position 1, the emergency-off key is unlocked and if the gearbox caver is closed. Note: To avoid a too heavy warm-up of the stepping motors the machine should be switched off during a major standstill.