A DESCRIPTION Accident Prevention Note: the feed power of the slides is 1000 Newton (100 kp). If program is not correct, the workpiece could be pressed out of the clamping device when it is not clamped and supported correctly. Therefore use tailstock center for supporting the workpiece. OF MACHINE - Safety Instructions Remove adjusting keys and wrenches! Even when chuck keys machine ts not being used. The should never be attached to the machine with chains or similar. Carry out maintenance measuring, adjusting, set-up, and resetting work only during standstill of the machine! Read instruction the machine. manual before working with Use chip hook for removing chips. Electrical connection:
The electrical connections must be carried out professionally. A grounding receptacle must be available. Never touch running machine parts! Never try to stop workpiece hand. or chuck with the Do not alter guards! Close belt guard before starting the machine. Never open belt guard while machine is running. Don't dismantle chip guard! Never work with dismanteled cover of E-control! Do not surpass the clamping capacity lathe chuck and independent chuck! See maximum capacities. Keep children and visitors away! over running (rotating) chucks. Be careful of extending chucks!
The machine of the Never reach should be stored so that children and visitors not acquainted with the use of the machine cannot start it. Switch machine off before servicing! Remove plug from socket. Always wear safety goggles! Be also aware that some materials (for examp. brass) spray while being worked on. Therefore, it is important that all persons near the machine are protected. The cover of the E-controt has to be removed by trained service people only. All Wear proper apparel! Loose sleeves could get caught in chuck or workpiece. Use Keep work area clean! benches invite accidents.
Ciuttered areas and electrical service and repair works (replacing fuses, boards etc.) have to be done by trained service people only. original spare parts, otherwise title whatsoever to guarantee! there is no