Downloaded from https://www.everyspec.com AMCP 706-197 circuit. The overall system then becomes binary inputs and outputs. It can be applied equivalent to a system using nonredundant in situations that call for either intermittent ideal MVT's. If the probability of survival for or continuous operation in time. Some con- an individual circuit is clusions which can be drawn from all this are: A I -A 1 1. Assuming ideal vote takers, a digital =10=23) system will be most reliable if majority logic then is applied at as low a level as pomsible, i.e., then when the system is divided into as many digi- F" 1tal subsystems, eaich followed by a majority R=[(2fl+ i) q ip2Dl-i ' vote takeras possible.
which is equivalent to the probability of suc- ?TF for the system will always be less than L (10-24) 2. On the oter hand, it is clear that the cess for m majority groups the MTF for the individual circuit. In the limit as n-, the system MTF can be 0.69 It can be shown that the maximum reli- times the MTF for the individual circuit. ability is achieved with nonideal vote takers if 3. The use of redundancy and majority (Ref. 5) logic gives the greatest improvement in reli. ',, A,= 1/(2n + 1) (10-25) ability in the case of large systems. i.e.. in where systems for which it is possible to PFeve large values of m. Xo = failure rate of the circuit 4. The full reliability improvement can A.
= failure rate of the vote taker be realized only if all circuits are working properly at time t = 0. This causes a checkout and repair problem. (2n + 1) = number of identical circui~s. 5. Unless the nonredundant fault prob- (10-26) ability q is small, very high degrees of redun- it is usually necessary to carry system out- dancy are required to reduce system failure put on a single line, in which case the redun- probability.
For q > 0.5, any degree of major- dancy scheme proposed by Moore and Shan- ity logic redundancy will actually e.-grade reli- non could be used to improve the reliability ability, although q > 0.5 is not very realistic of system output, thus eliminating the final for anything but deep-space probes. vote taker from the analytic expression. This 6. If nonredundant MVT',% of limited form of redundancy is usually associated with reliability are used anywhere in a redundant MVT'- MVT's qb qt qb 0* %qb qqb q Final ,,_,j IMVT 2 m MVT = Majority Vote Taker Failure probability is shown for each element. FIGURE 1&0. Reliability Block Diagram for Circuit With Threefold Majority Logic' *. 10-10